Related products

• 
  Soil Test Instruments

  Static Cone Penetrometer, 30KN (300KGF) Capacity

  The drive is by means of a rack and pinion manually through a gearing arrangement. The gear box and pinion are fixed on two handles, sprockets and chain arrangement. The movement of the rack is guided by a bracket ( attached to the rack) and two pillars. The penetration resistance i.e. the pressure is indicated on hydraulic gauges through a hydraulic measuring head. Two pressure gauges of 15cm dia dial and 2 capacities 0-160kg/cm are provided. An automatic cut-off valve, to protect the low capacity gauge from being overloaded is provided. The 2 valve can be adjusted and locked at desirable values between 20 to 60cm . A provision is made to anchor the unit to the ground (with the help of four anchors supplied with the unit) and there is a provision for lateral 2 movement of the unit so that subsequent tests could be performed without shifting the entire anchorage. A 10cm penetration cone with friction jacket is provided along with fifteen mantle tubes (non-uniform having an effective length of 1 m each with sounding rods for finding out the cone (point) resistance or jacket friction

• 
  Soil Test Instruments

  Relative Density Test

  The equipment is used for the determination of the relative density of cohesion less free draining soils and meets the essential requirements.Specification :The equipment consists one each of: Vibratory table, with a cushioned steel vibrating decks about 75cm x 75cm. It has a frequency of approximately 3600 vibratory table, minute under a 11.5kg load. Amplitude is variable in between 0.65mm in step of 0.05 to 0.25mm, 0.25 to 0.45 mm and 0.45 to 0.65mm. Suitable for operations on 415V, Three Phase supply. Cylindrical metal unit weight mould, 3000ml. Capacity.Guide sleeve with clamp assembly. Surcharges base plate for mould. Handle for surcharge base plate. Surcharge weight. The total weight together with surcharge base plate and handle is equipment to 140 kg. /sq. cm. For mould. Cylindrical metal unit weight mould 15000 ml. capacity. (Total weight together with the above mould & surcharge weight is equivalent to 140 kg./sq. cm) dial gauge 0.01mm x 50mm travel. Extension piece 25mm for dial gauge.

• 
  Soil Test Instruments

  Shrinkage Limit Apparatus

  Shrinkage Limit is the maximum water content at which a reduction in water content does not cause an appreciable reduction in volume of the soil mass. At shrinkage limit, on further reduction in water, air enters into the voids of soils and thus keeps the volume constant. The apparatus can be used to determine shrinkage limit and to calculate other shrinkage factors like shrinkage ratio, shrinkage index and volumetric shrinkage. Salient Features Specifications : Set consists of one each :- 1. Porcelain evaporating Dish. 2. Shrinkage Dish 3. Glass Cup. 4. Perspex plate with three metal prongs 5. Perspex plate. 6. Flexible spatula 7. Glass cylinder 25ml x 0.5mlsupplied without mercury.

• 
  Soil Test Instruments

  Sand Density Cone Apparatus

  Used to determine the in-situ density of fine grained compacted soil. The test consist in digging a hole into the ground and then collect, dry and weight the sampled soil. The hole is then filled with dry sand from the cone container. The apparatus consist of a double metal cone, one plastic 5 lts jar & a metal tray with centre hole. Size of the cone is 6½” (165.1mm)
  Note:On request 12” (305 mm) Sand Density Cone Apparatus is also supplied at an extra cost.